FLEX40116 FINGER RECEPTOR .635 INCH DIAMETER

• Replacement finger receptor for Flexxifinger Pulse Crop Lifters
• Holds 0.635 in. (16 mm) diameter nylon fingers
• Gold-coloured adjustable receptor lets the operator fine-tune the lifter’s forward lifting point for specific conditions
• Receptor only — finger, bolt and nut sold separately (see FLEX40116.1 for the kit with bolt and nut)
• Use with Pulse nylon fingers 33048 (0.635 x 2.75 in.) or 33050 (0.635 x 4.75 in.), sold separately

Technical data

• 0.635 in. (16 mm) diameter receptor
• Fits Pulse Crop Lifters 70060 (N) and 70062 (J) — listed in the Flexxifinger dealer binder parts listings for both rails
• Receptor hardware (sold separately): 32300 8 mm carriage bolt and 32301 8 mm lock nut
• Parts diagram: Flexxifinger dealer binder (parts listings and diagrams)

Installation

• Install the nylon finger into the receptor: holding the lifter in your hand, rest the back of the receptor between and on top of the jaws of a vise, so the receptor spans the distance between the jaws
• Slide the nylon finger tail down into the front of the receptor, matching up the flat section of the receptor with the flat section on the finger body, like a key into a lock
• Use a rubber mallet or a hammer to firmly tap the nylon finger until it has bottomed completely into the receptor — the fit is very snug, and spraying the finger with multipurpose lubricant helps if it is difficult to push in
• The receptor is only loosely attached at the factory — tighten it, but do not overtighten, because it will require adjustment once all the fingers are in place; once the finger has bottomed, rotate it 90 degrees with pliers to lock it into place, with the right side down
• Installation guide: Pulse Crop Lifters — Installation & Adjustment Instructions (Flexxifinger, PDF)

Tips & tricks

• If a finger will not push into the receptor, check that the flat sections of the finger and receptor are not misaligned before forcing it — attempting to force a misaligned finger may damage the finger