FLEX33058 NYLON FINGER

• Heavy Duty nylon finger with a forward lifting point 5.5 in. (140 mm) long
• Multi-purpose finger that works well in a variety of soils, even damp clay soil
• For all crop types
• Sold individually

Technical data

• Diameter x length: 1.01 in. (26 mm) x 5.5 in. (140 mm)
• Material: nylon
• Touchdown pad: no
• Tail: 7 in. (178 mm)
• Fits the 1.01 in. (26 mm) receptor on Heavy Duty crop lifters 70050, 70052 and 70050-MD-2, and on FlexxiFloat 100 lifters

Installation

• Seat the finger fully into the lifter receptor, matching the flat section on the finger body to the flat section on the receptor, like a key into a lock; tap with a rubber mallet or hammer until it has bottomed completely into the receptor
• Once fully seated, rotate the finger 90 degrees with pliers or a wrench to lock it into place; if it is hard to turn, it may not be fully seated
• Loosen the receptor lock nut from the carriage bolt to adjust the finger angle; the adjustable receptor lets the operator fine-tune the forward lifting point for specific conditions
• Set the finger angle to a maximum of 25 degrees from the ground, with the finger tip about 1/2 in. (13 mm) to 3/4 in. (19 mm) above the ground, and set all lifters to the same angle so they work in unison
• The tail guides the plant material over the knife
• Installation guide: Heavy Duty Crop Lifters — Installation & Adjustment Instructions (Flexxifinger, PDF)

Tips & tricks

• Multi-purpose finger for a variety of soils, including damp clay soil
• Suits all crop types, including pulses, cereals, rice, oilseed, forage and other specialty crops in even ground conditions
• Leaves approximately 3 in. (75 mm) of stubble