33050 NYLON FINGER

• Pulse Crop nylon finger with a forward lifting point 4.75 in. (120 mm) long
• For pulse crops where cutting close to the ground is required
• Sold individually

Technical data

• Diameter x length: 0.635 in. (16 mm) x 4.75 in. (120 mm)
• Material: nylon
• Touchdown pad: no
• Tail: 7 in. (178 mm)
• Fits the 0.635 in. (16 mm) receptor on Pulse Crop lifters 70060, 70062 and 70060-MD-2

Installation

• Seat the finger fully into the lifter receptor, matching the flat section on the finger body to the flat section on the receptor, like a key into a lock; tap with a rubber mallet or hammer until it has fully seated into the receptor
• Once fully seated, rotate the finger 90 degrees with pliers or a wrench to lock it into place; if it is hard to turn, it may not be fully seated
• Loosen the receptor lock nut from the carriage bolt to adjust the finger angle; the adjustable receptor lets the operator fine-tune the location of the forward lifting point for specific conditions
• Set the finger angle to a maximum of 25 degrees from the ground, with the finger tip about 1/2 in. (13 mm) to 3/4 in. (19 mm) above the ground, and set all lifters to the same angle so they work in unison
• The tail of the finger guides the plant material over the knife
• Installation guide: Pulse Crop Lifters — Installation & Adjustment Instructions (Flexxifinger, PDF)

Tips & tricks

• Recommended when cutting within 1.5 in. to 2.5 in. of the ground
• For peas, lentils, chickpeas, edible beans and straight combining in desiccated crops where cutting close to the ground is required