FLEX33030 NYLON PULSE CROP FINGER .508 X 4.25 INCH LONG (ORIGINAL STYLE)

• Pulse Crop nylon finger, original style, 4.25 in. long
• Flexxifinger also lists this finger as a cereal finger (old style)
• Replacement finger for Flexxifinger Pulse Crop Lifters
• Sold individually

Technical data

• Diameter x length: 0.508 in. x 4.25 in.
• Material: nylon
• Style: original style (old style)
• Fits old-style 0.508 in. receptors on Pulse Crop lifters; it is not the current 0.635 in. Pulse finger size

Installation

• Seat the finger fully into the lifter receptor, matching the flat section on the finger body to the flat section on the receptor, like a key into a lock; tap with a rubber mallet or hammer until it has fully seated into the receptor
• Once fully seated, rotate the finger 90 degrees with pliers or a wrench to lock it into place; if it is hard to turn, it may not be fully seated
• Loosen the receptor lock nut from the carriage bolt to adjust the finger angle; the adjustable receptor lets the operator fine-tune the location of the forward lifting point for specific conditions
• Set the finger angle to a maximum of 25 degrees from the ground, with the finger tip about 1/2 in. (13 mm) to 3/4 in. (19 mm) above the ground, and set all lifters to the same angle so they work in unison
• The tail of the finger guides the plant material over the knife
• Installation guide: Pulse Crop Lifters — Installation & Adjustment Instructions (Flexxifinger, PDF)