FLEX33004 NYLON FINGER .635 X 3 INCH, NO TAIL

• Nylon finger, no tail
• Replacement finger for Original HighCut lifters
• Sold individually

Technical data

• Diameter x length: 0.635 in. x 3 in.
• Material: nylon
• Tail: none (no tail)
• Replacement finger for Original HighCut lifters (sheet match to the 0.635 in. x 3 in. finger supplied with Original HighCut lifters)
• Also listed in Flexxifinger's dealer parts listing as the nylon tail for FlexxiFloat 200 and 250 lifters

Installation

• As the FlexxiFloat 200/250 nylon tail: tighten the lifter rail in a vise, insert the round tenon of the nylon tail into the round hole at the back of the arm, with the rounded step of the tail fitting into the groove, and drive the screw into the tail
• The lifter tail has been left uninstalled (but included) on FlexxiFloat 200/250 lifters, so the operator has the option to use the lifter with or without the tail; the tail can provide additional lift in lighter crop situations but is not recommended when harvesting heavy crops
• Installation guide: FlexxiFloat 200 and 250 — Installation and Adjustment Instructions (Flexxifinger, PDF)